YAMAHA FUEL TAP/GAS VALVE PETCOCK GASKET REBUILD KIT DT250 DT400 IT175 IT250 AT1

Description

Don’t be fooled by others selling kits with aftermarket Chinese parts.  They don’t last.
Don’t waste your money on a crappy aftermarket replacement petcock that will be leaking in a year.  You can replace the seals in your OEM petcock and have it perform like new again.  This is a seal replacement kit for your OEM petcock.
It will included:
1 Mounting Base Gasket (#22 in picture)
1 Bowl Gasket
(#20 in picture)
1 Packing Gasket
(#14 in picture)
1 Lever
Gasket
(#15 in picture)
2 Stainless Steel Allen head replacement screws
(#19 in picture)
This kit is for the gaskets only.  No other Petcock parts are included. Don’t be fooled by copycat sellers using non-OEM and non-Viton rubber parts.
1)Base gasket goes between the petcock base and the tank. After years,
this gasket becomes flat and no longer provides a adequate seal, so when
you remove your petcock, you should replace this gasket. This seal is
round, but it forms into the groove of your petcock base.
2)Bowl
gasket goes between the screen and the bowl. The key to a successful
installation on this gasket is not to over tighten. No more than 1/2
turn after firm contact is all you need.
3)Packing gasket goes behind the lever face.
4)Lever gasket goes into the groove of the lever and should be lubricated before installation.
5)Screws can be used or use your old ones.